Everything you will need for this project can be found around your home or garage.
Cost: Free.99
( Using materials from range day and other DIYs.)
Time: 15 to 30 minutes
( Depending on how long it takes you to gather materials.)
Cost: Free.99
( Using materials from range day and other DIYs.)
Time: 15 to 30 minutes
( Depending on how long it takes you to gather materials.)
1. You will need four(4) plastic valve stem caps.
2. You will need four (4) shells, which can be 9mm or .40 cal.
3. Tools needed:
• Glue
• Pilers
• A Dremal or sandpaper
• Glue
• Pilers
• A Dremal or sandpaper
4. Shave down each cap enough so it fits tightly into your selected shell.
5. After applying a small amount of glue take your Pilers and slowly press your cap into the selected shell.
6. Ensure that your cap is pressed flush inside of shell.